Tips for Routing

1) First route the long signals like supply
2) Then route the nest farther signal and so on.
3) For nearby signals you can use zero ohm as jumper at the point of crossing 

Comments

Post a Comment

Popular posts from this blog

HackRF with srsLTE and openlte

HackRF with srsLTE srsLTE supports USRP, bladeRF and SoapySDR. HackRF is interfaced to srsLTE via SoapySDR. 1)First build srsLTE 2)Install SoapySDR and test SoapySDR to detect HackRF One Follow link here: https://github.com/pothosware/SoapyHackRF/wiki Dependencies Install libhackrf - https://github.com/mossmann/hackrf/wiki Install SoapySDR: https://github.com/pothosware/SoapySDR/wiki Or install Hack RF packages on Ubuntu: I have followed this procedure: sudo add-apt-repository -y ppa:myriadrf/drivers sudo apt-get update sudo apt-get install hackrf libhackrf-dev Building Soapy Hack RF The CMake build system will locate libhackrf and SoapySDR development files on your system. The plugin module will be built and installed into the SoapySDR modules directories. git clone https://github.com/pothosware/SoapyHackRF.git cd SoapyHackRF mkdir build cd build cmake .. make sudo make install Probing Soapy Hack RF SoapySDRUtil --probe=...
Read more

Blinking a LED in STM32F103C8T6 (Blue Pill) Board

1) First Include STM32F103xB_CUBELIB and cmsis_core in the project #include "stm32f1xx.h" void waitForAmoment(int Moment) { volatile int i,j; for (i = 0; i < Moment; ++i) { j++; } } int main(void) { //Enable the GPIO Clock by AHB and RCC RCC->APB2ENR |= RCC_APB2ENR_IOPCEN; GPIOC ->CRH |= GPIO_CRH_MODE13; //PC13 in output mode, 50 MHz GPIOC->CRH &= ~(GPIO_CRH_CNF13); //PC13 General Purpose Output, Push Pull Config     while(1)     {     GPIOC->BSRR |= GPIO_BSRR_BS13;     waitForAmoment(1000000);     GPIOC->BRR |= GPIO_BRR_BR13;     waitForAmoment(1000000);     } }
Read more

Read Continuously from Serial Port in QT

#include <QCoreApplication> #include <QtSerialPort/QSerialPort> #include <Qdebug> QSerialPort serial; int main() { //COM Port Configuration serial.setPortName( "COM6" ); serial.setBaudRate( QSerialPort :: Baud9600 ); serial.setDataBits( QSerialPort :: Data8 ); serial.setParity( QSerialPort :: NoParity ); serial.setStopBits( QSerialPort :: OneStop ); serial.setFlowControl( QSerialPort :: NoFlowControl ); serial. open ( QIODevice :: ReadWrite ); char buffer[ 50 ]; while ( 1 ) { serial.waitForReadyRead(); // blocks calls until new data is available for reading. serial.readLine(buffer, 50 ); qDebug ()<<buffer; } serial. close (); }
Read more